2.10 Communications with a JTEKT PLC (TOYOPUC Protocol)
Message Functions
2-300
Connection Number (PARAM10)
Specify the remote station.
If the communications device is the 218IFD, enter the connection number. The valid setting range is given
in the following table.
Note: Enter the same connection number as displayed in the 218IFD Detail Definition Dialog Box in the MPE720.
Options (PARAM11)
This parameter is not used for the TOYOPUC protocol.
Function Code (PARAM12)
Set the function code to send.
You can use the functions that are registered to the function codes.
Reserved for System (PARAM13)
This parameter is used by the system.
Communications Device Connection Number Description
218IFD 1 to 20
Specifies the connection number of the remote station to
send the message to.
MEMOBUS Function File Memory Frame Type
Code Meaning Code Function
31 hex
Writes to a fixed buffer in
units of one word.
60 hex: Command
E0 hex: Response
Sends file memory data.
Do not change the value of PARAM13 from a user program or by any other means.
To Next Page
Loading...
