EasyManua.ls Logo

YASKAWA MP3000 Series - Using the MSG-RCVE Function with the MP3000 as a Slave

YASKAWA MP3000 Series
435 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2.4 Communications with MP-series Controllers
Using the MSG-RCVE Function with the MP3000 as a Slave
2-30
Using the MSG-RCVE Function with the MP3000 as a Slave
You can use the MSG-RCVE function together with automatic reception by maintaining a separate con-
nection.
This section describes how to communicate with an MP2300-series Controller by using the MSG-RCVE
function.
MP2300MP3000
218IFD
EthernetEthernet
DC24V
DC 0V
MP2300
YASKAWA
TEST
RDY
ALM
TX
RUN
ERR
BAT
MON
CNFG
INT
SUP
STOP
SW1
OFF ON
BATTERY
CPU I/O
218IF-01
ERR
COL
RX
RUN
STRX
TX
INIT
TEST
ONOFF
PORT
10Base-T
MP3000
(local station)
Slave
Master
Communications Protocol
Connection Type
Data Code Binary or ASCII
MSG-RCVE function
(ladder application)
MSG-SND function
(ladder application)
218IF-01
Optional
Module
Extended MEMOBUS protocol
TCP or UDP
MEMOBUS protocol
MP2300
(remote station)

Table of Contents

Other manuals for YASKAWA MP3000 Series

Related product manuals