900-200-100 17/57
Description of Technical Terms
The following table shows the meanings of terms used in this manual.
Σ-V Series/Σ-7 Series: SGMJV, SGMAV, SGMVV, SGMPS, SGMGV, SGMSV, or
SGMCS (Direct Drive) servomotor
Σ-7 Series: SGM7J, SGM7A, SGM7P, or SGM7G servomotor
Linear Σ Series: SGLGW, SGLFW, SGLTW, or SGLC servomotor
Σ-7 Series SGD7S or SGD7W SERVOPACK
A set including a servomotor and SERVOPACK (i.e., a servo amplifier)
A servo control system that includes the combination of a servo drive with a host
controller and peripheral devices
SGD7S SERVOPACK with a MECHATROLINK-III communications reference interface
SGD7S SERVOPACK with a CoE(CANOpen Over EtherCAT) communications
reference interface
Generic term for an Option Module that provides safety functions and is mounted on
a SGD7S SERVOPACK
The option module that provides safety functions specified in this manual.
Handy type operator connected to SERVOPACKs
Power supply to motor is turned OFF by shutting OFF the base current to the power
transistor that supplies power to the motor.
Hardwire BaseBlock Function
(HWBB)
Safety function in the SERVOPACK
This is the safety function that is equivalent to the Safe Torque Off function defined
in IEC 61800-5-2.
This is one of safety functions defined in IEC 61800-5-2.
This is the safety function that shuts OFF power supply to the motor.
This is one of safety functions defined in IEC 61800-5-2.
This is the safety function that starts deceleration of the motor and executes the
STO function after a specified time has passed.
This is one of safety functions defined in IEC 61800-5-2.
This is the safety function that starts deceleration of the motor and prevents the
motor from stopping at a distance greater than the allowable deviation from the
specified position after a specified time has passed.
Safely-Limited Speed (SLS)
This is one of safety functions defined in IEC 61800-5-2.
This is the safety function that prevents the motor speed from exceeding the
specified speed.
To Next Page
Loading...
