900-200-100 37/57
3.1.2. SGDV-OSA01A000FT900
This wiring example shows in case of using SGDV-OSA01A000FT900 and applicable SERVOPACK, and the HWBB signal
is connected to the CN8 of the SERVOPACK.
If you do not use the CN8 of the SERVOPACK, you shall connect the jumper connector to the CN8. In that case, the
wiring is same as the chapter 3.1.1 .
■Three-Phase, 400 VAC
・SGD7S-□□□D□0□ + SGDV-OSA01A000FT900
Safety Function Device Cable
Servomotor Main Circuit Cable
Safety Function Device Cable
To Next Page
Loading...
