Yealink SIP-T27G Administrator's Guide

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
260
######Set a Park key######
linekey.1.type = 10
linekey.1.value =*01
linekey.1.line = 1
linekey.1.label =Bill
######Set a Retrieve key####
linekey.3.type = 56
linekey.3.line = 1
linekey.3.value =*11
linekey.3.label =Retrieve Bill
After provisioning, you can easily press the Park key (line key 1) to park a call to the specific shared parking lot
(*01) during a call, and press the Retrieve key (line key 3) to retrieve the parked call from the shared parking lot
(*01) using the retrieve code (*11). You can only perform call park feature on the specific line (line 1).
If the “features.call_park.line_restriction.enable” is set to 0 (Disabled), the phone will park/retrieve the call to the
server on the current line in use.
Note: In Transfer call park mode, if you press the Park key when the phone is idle, the Park key will invoke the call park
code. Therefore, you can use a Park key to park and retrieve a call. In this case, you need to assign the park retrieve code
(*11) to “features.call_park.park_code”. When you press the Park key again on the idle screen, the phone will dial out “*11*01”
to retrieve the parked call.
Example: Setting a Line Key as Directed Pickup Key
Scenario Conditions Related Topic
account.1.direct_pickup_code = *97
or
features.pickup.direct_pickup_code = *97
Directed Call Pickup
Example
linekey.1.type = 9
linekey.1.line =1
linekey.1.value= 4603
linekey.1.label=Bill
After provisioning, you can easily press the Directed Pickup key (line key 1) to pick up an incoming call to a specific
phone (4603).
Note: The Directed Pickup invokes the directed pickup code by default. Therefore, the phone dials out *974603 to pick up a
call. If the directed code is not set, you can assign code and extension to “linekey.X.value”, for example, “*974603”.
Example: Setting a Line Key as Group Pickup Key
The following example shows the configuration for a group pickup key.
Example
linekey.1.type = 23
linekey.1.line =1
linekey.1.value =*98

Yealink SIP-T27G Specifications

General

Mounting	Desk/Wall
Handset type	Wired handset
Product type	IP Phone
Product color	Black, Gold
Wall mountable	Yes
Display diagonal	3.66 \
Display resolution	240 x 120 pixels
RJ-9 ports quantity	2
USB 2.0 ports quantity	1
Voice codecs	CNG, G.711, G.722, G.723.1, G.726, G.729, G.729ab, VAD, iLBC
Dual-Tone Multi-Frequency (DTMF) modes	SIP info
Lines quantity	8 lines
Phonebook capacity	1000 entries
Number of VoIP accounts	6
Bluetooth	-
Security algorithms	AES, MD5
Networking standards	IEEE 802.1Q, IEEE 802.1p, IEEE 802.1x, IEEE 802.3af
Ethernet LAN interface type	Gigabit Ethernet
Volume control	Digital
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	10 - 95 %
Cables included	LAN (RJ-45)
Number of handles included	1 pc(s)
Harmonized System (HS) code	85171800

Weight and Dimensions

Depth	210 mm
Width	265 mm
Height	170.5 mm