Yealink VC400 - Page 101

Configuring Network
85
port used, and then informs the client. For more information, refer to RFC3489.
Capturing packets after you enable the STUN feature, you can find that the VC400/VC120 sends
Binding Request to the STUN server, and then mapped IP address and port is placed in the
Binding Response: Binding Success Response MAPPED-ADDRESS: 59.61.92.59:19232.
STUN feature parameters on the system are described below:
Parameter
Description
Configuration Method
Active
Enables or disables the STUN
(Simple Traversal of UDP over NATs)
feature on the system.
Default: Disabled
Remote Control
Web User Interface
STUN Server
Configures the IP address or the
domain name of the STUN (Simple
Traversal of UDP over NATs) server.
Default: Blank
Remote Control
Web User Interface
STUN Port
Configures the port of the STUN
(Simple Traversal of UDP over NATs)
server.
Default: 3478
Remote Control
Web User Interface
NAT Traversal
Configures the NAT traversal type.
You can configure it for the SIP
account or SIP IP call separately.
 Disabled
 STUN
 StaticNat
Default: Disabled
Remote Control
Web User Interface