Yealink VC400 - Enabling H.460 Support for H.323 Calls

Configuring Call Preferences
135
Enabling H.460 Support for H.323 Calls
Yealink video conferencing systems support firewall traversal of H.323 calls using H.460
protocols. You must have an H.460 server configured in your environment for this feature to
function properly.
Note
The H.460 firewall traversal parameter is described below:
Parameter
Description
Configuration Method
Gatekeeper Mode
Configures the gatekeeper mode.
 Disabled—the system does
not use a gatekeeper.
 Auto—the system
automatically discovers a
gatekeeper.
 Manual—specify the IP
address and port for the
gatekeeper manually.
Default: Disabled
Remote Control
Web User Interface
Gatekeeper IP Address
1/Gatekeeper Server 1
Configures the IP address of the
primary H.460 server.
Note: It is configurable only when
the Gatekeeper Mode is set to
Manual.
Remote Control
Web User Interface
Gatekeeper Port
1/Port
Configures the port of the primary
H.460 server.
Valid values: Integer from 0 to
Remote Control
Web User Interface
If you configure H.323 settings and enable H.460 support, the system ignores Static NAT settings.
For more information on NAT, refer to Static NAT on page 81.