Yealink VC400 - Administrator Password

Administrator’s Guide for Yealink Video Conferencing Systems
248
Parameter
Description
Configuration Method
when the user mode is enabled. The
system supports ASCII characters
32-126(0x20-0x7E) in passwords.
You can leave the password blank.
To configure user mode via web user interface:
1. Click on Security->Security.
2. Select User from the pull-down list of User Type.
3. Select Enabled from the pull-down list of User Mode.
4. Configure a password or leave it blank in the User Password field.
5. Click Confirm to accept the change.
Administrator Password
The default enabled user type is administrator. Users can log into the web user interface and
access the “Advanced” menu option with administrator privilege by default. The default
administrator password is “0000” and can be only changed by an administrator. For security
reasons, the administrator should change the default administrator password as soon as
possible. The system supports ASCII characters 32-126(0x20-0x7E) in passwords.
Administrator password parameters on the system are described below:
Parameter
Description
Configuration Method
User Type
Specifies the user type.
Default: Administrator
Note: To configure a new
administrator password, you need to
select Administrator for this
parameter.
Web User Interface
Old Password
Enters the old administrator
password.
Note: The default administrator
password is “0000”.
Remote Control
Web User Interface