System Management
239
Search Source List in Dialing
When you enter a few characters in the dialing screen, the system will search for contacts from
the enabled search source lists, and display the result in the dialing screen. The lists can be
History, Local Directory, Cloud Contact (including your Yealink Cloud contacts and YMS contacts)
and LDAP.
To match the desired list, you need to enable the search source list first. If you want to match the
LADP list, make sure LDAP is already configured. For more information on how to configure
LDAP, refer to LDAP on page 232.
To configure search source list in dialing via web user interface:
1. Click on Directory->Setting.
2. In the Search Source List In Dialing block, select the desired list from the Disabled column
and click .
The selected list appears in the Enabled column.
3. Repeat step 2 to add more lists to the Enabled column.
4. (Optional.) To remove a list from the Enabled column, select the desired list and then
click .
5. To adjust the display order of the enabled list, select the desired list, and click
or .
6. Click Confirm to accept the change.
Dual Screen
The VC400/VC120 has two display ports. When connecting only one display device to the
VC400/VC120 Codec, Display1 port is the only available port. To make it easier for users to view
video images, users can connect two display devices to Display1 and Display2 ports respectively.
When two display devices are connected to the VC400/VC120 Codec, the status bar of the
primary display device will display icon.
To Next Page
Loading...
