Administrator’s Guide for Yealink Video Conferencing Systems
156
If Auto is selected, the system will
select the appropriate uplink
bandwidth automatically.
Specifies the maximum receiving
bandwidth for the system.
Default: Auto
If Auto is selected, the system will
select the appropriate downlink
bandwidth automatically.
Remote Control
Web User Interface
To configure bandwidth settings via web user interface:
1. Click on Setting->Call Features.
2. Select the desired value from the pull-down list of Uplink Bandwidth.
3. Select the desired value from the pull-down list of Downlink Bandwidth.
4. Click Confirm to accept the change.
To configure bandwidth settings via the remote control:
1. Select Menu->Call Features->Bandwidth Settings.
2. Select the desired value from the pull-down list of Uplink Bandwidth.
3. Select the desired value from the pull-down list of Downlink Bandwidth.
4. Press the Save soft key to accept the change.
Note
The priority of bandwidth is as follows: System bandwidth>Contact bandwidth (refer to add local
contacts).
For example: the s
ystem bandwidth is 512kbps, if contact bandwidth is set to a value greater than
512bps, than the actual contact bandwidth will be 512bps. If contact bandwidth is set to a value
less than 512bps, than the actual contact bandwidth will be the value set by user.
To Next Page
Loading...
