Configuring System Settings
185
The meeting password parameters are described below:
Enable or disable the meeting
password feature.
Default: Off
Remote Control
Web User Interface
Configures the meeting password.
Default: blank
Remote Control
Web User Interface
To configure the meeting password via web user interface:
1. Click on Setting->General.
2. Select the desired value from the Meeting Password pull-down list.
3. Enter the desired value in the Password field.
4. Click Confirm to accept the change.
To configure the meeting password via the remote control:
1. Select Menu->Basic->Meeting Password.
2. Check the Meeting Password checkbox.
3. Enter the meeting password in the Password field.
4. Press the Save soft key to accept the change.
People can press IP##meeting password or meeting password@IP to dial your system or join
your conference call. For example: your IP address is 10.3.6.201 and you set 123 as your meeting
password. People should press 10.3.6.201##123 or 123@10.3.6.201 to dial your system or join
your conference call. If people call you without a meeting password or with a wrong meeting
password, the call will fail.
To Next Page
Loading...
