Yealink VC400 - Page 211

Configuring System Settings
195
Parameter
Description
Configuration Method
1500
Default: 1500
Note: If you change this parameter,
the system will reboot to make the
change take effect.
To configure MTU via web user interface:
1. Click on Network->Advanced.
2. In the MTU block, enter the desired value in the Video MTU field.
3. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
4. Click Confirm to reboot the system immediately.
To configure MTU via the remote control:
1. Select Menu->Advanced (default password: 0000) ->Advanced Network.
2. Enter the desired value in the Video MTU(1000-1500) field.
3. Press the Save soft key to accept the change.
The display device prompts “Reboot now?”.
4. Select OK to reboot the system immediately.