Administrator’s Guide for Yealink Video Conferencing Systems
250
Web server type parameters on the system are described below:
Enables or disables the user to
access the web user interface of the
system using the HTTP protocol.
Default: Enabled
Remote Control
Web User Interface
Specifies the HTTP port for the user
to access the web user interface of
the system.
Valid Values: 1-65535
Default: 80
Note: Ensure that the configured
port is not used.
Enables or disables the user to
access the web user interface of the
system using the HTTPS protocol.
Default: Enabled
Remote Control
Web User Interface
Specifies the HTTPS port for the user
to access the web user interface of
the system.
Valid Values: 1-65535
Default: 443
Note: Ensure that the configured
port is not used.
To configure web server type via web user interface:
1. Click on Network->Advanced.
2. Select the desired value from the pull-down list of HTTP.
3. Enter the desired HTTP port in the HTTP Port field.
4. Select the desired value from the pull-down list of HTTPS.
To Next Page
Loading...
