Yealink VC400 - Page 80

Administrator’s Guide for Yealink Video Conferencing Systems
64
TLV Type
TLV Name
Description
Inventory – Firmware
Revision
Firmware revision of the system.
Inventory – Software
Revision
Software revision of the system.
Inventory – Serial
Number
Serial number of the system.
Inventory –
Manufacturer Name
Manufacturer name of the system.
The default value is “Yealink”.
Inventory – Model
Name
Model name of the system.
The default value is “VCS”.
Asset ID
Assertion identifier of the system.
Parameters of LLDP feature on the system are described below.
Parameter
Description
Configuration Method
LLDP->Active
Enables or disables LLDP feature on
the system.
Default: Disabled
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Remote Control
Web User Interface
Packet
Interval(1-3600s)
Configures the interval (in seconds)
for the system to send LLDP
requests.
Default: 60
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Remote Control
Web User Interface
To configure LLDP via web user interface:
1. Click on Network->Advanced.
2. In the LLDP block, select the desired value from the pull-down list of Active.