6-2
IM CW240E
6.1 Settings
Before making measurements, you need to set up the measurement conditions,
data save, and other information beforehand.
● Screen Configuration
The Setup screen consists of the following screens:
Tab
(Use the right and left
cursor keys to switch)
• General (1/2, 2/2)
• Save (1/2, 2/2)
• Communication
Tab
(Use the right and left
cursor keys to switch)
• Volt. Quality
• Hardware
• Analog I/O (optional)
NOTE
• Setting items (with the exception of some) cannot be changed during integra-
tion measurements (including when on standby).
• Unless integral measured data has been cleared, setting items (with the ex-
ception of some) cannot be changed. To change a setting item, press the F5
key (HOLD/Clear) for more than 3 seconds on the Measure screen to clear
integral measured data and then change the setting.
Chapter 6 Configuring Settings
To Next Page
Loading...
Need help?
General
