1-3
IM CW240E
Product Overview
1
● Wide measurement range
Voltage range: 150 V, 300 V, 600 V, and 1000 V
Current range: compatible with 7 types of clamp-on current probes
From 200 mA to 3000 A maximum
● Power quality analysis measurement
Power quality analysis can be made using harmonics (1st to 50th order), voltage
dip/swell/momentary interruption, and waveform measurement functions.
● Wiring check and setup check
• The wiring check function allows you to check a voltage phase sequence or
reverse connection of clamp-on current probes.
• The setup check function allows you to check settings for integration
measurements.
● Data management and communication
• Data can be saved using a personal computer (PC) card.
• Data can be transferred to a PC and setup can be made from the PC through
communications.
● Equipped with 4CH DA outputs and 2CH analog inputs (DC V) (optional)
• Measured values can be converted into DC voltage and then analog-output to
a recorder or other devices.
• Analog outputs from a thermometer or illuminometer can be connected to the
analog input terminals of the CW240 to measure power data and
environmental data together.
1.1 Product Overview
To Next Page
Loading...
Need help?
General
