<4. Setting converter>
4-31
IM 12A01F01-03EN 2nd Edition : Feb. 19, 2019-00
Table 4.5
Location Alarm Alarm name default*1
Housing Measure alarm F
Ratio calc. error *2 F
Passage calc. error *2 F
Rejection calc. error *2 F
Deviation calc. error *2 F
Script Error 1/2/3/4 *2 N
I/O Alarm Fail safe occur F
Maintenance status Outputs in HOLD 1/2/3/4 N
Wash response failure 1/2/3/4*4 M
Setting alarm F
Error in mA table 1/2/3/4 F
Display setting error 1-1/2/3/4, 2-1/2/3/4 C
HART setting error N
F
PH Device status SENCOM comm. error *3 F
Measure alarm Temperature too high S
Temperature too low S
pH too high S
pH too low S
ORP too high S
ORP too low S
rH too high S
rH too low S
Impedance 1 too high M
Impedance 1 too low M
Impedance 2 too high M
Impedance 2 too low N
pH temp comp warning S
SSA temp outside spec S
Sensor status Sensor not detect F
Temp element not detect F
ID chip failure F
LE not detect F
Calibration Due N
imp1 glasbreak detect F
imp2 glasbreak detect F
To Next Page
Loading...
