<4. Setting converter>
4-32
IM 12A01F01-03EN 2nd Edition : Feb. 19, 2019-00
Location Alarm Alarm name default*1
SC Device status SENCOM comm. error *3 F
Measure alarm Temperature too high S
Temperature too low S
Conductivity too high S
Conductivity too low S
Temp comp1 warning S
Temp comp2 warning S
USP limit exceeded N
USP margin exceeded N
Polarization detect N
1st comp. matrix error F
2nd comp. matrix error F
Concentration table error F
SSA temp outside spec S
Sensor status Sensor not detect F
Temp element not detect F
ID chip failure F
Calibration Due N
ISC Device status SENCOM comm. error *3 F
Measure alarm Temperature too high S
Temperature too low S
Conductivity too high S
Conductivity too low S
Temp comp1 warning S
Temp comp2 warning S
1st comp. matrix error F
2nd comp. matrix error F
Concentration table error F
SSA temp outside spec S
Sensor status Sensor not detect F
Temp element not detect F
ID chip failure F
Calibration Due N
To Next Page
Loading...
