7-23
IM 04L20A01-01E
7
Data Save/Load Operations
• Loading setup data
MENU key (switch to setting mode) > Hold down the FUNC key for 3 seconds
(switch to basic setting mode) > #8 soft key (select [Save/Load, Initialize]) > #2 soft
key (select [Load settings])
From the operation mode, use the above keys to open the following display.
Note
If you attempt to load the setup data and the external storage medium does not contain the
setup data, a message “There is no setting file” appears.
Operations on the Display
• Saving setup data
See “
Saving Setup Data
” on page 7-21.
• Loading setup data
See “
Loading Setup Data of Setting Mode
” on page 7-22.
Setup Items
Saving Setup Data
See the description in “
Setup Items
” on page 7-22.
Loading Setup Data
• Loading the setup data in basic setting mode loads all of the setup data of setting
mode and basic setting mode. To load only the setup data of setting mode, load the
setup data in setting mode.
• If the contents of the loaded setup data are invalid, refer to the error message log that
appears by pressing the FUNC key and soft keys.
For the procedure of displaying the error message log, see section 9.4.
7.9 Saving and Loading Setup Data
To Next Page
Loading...
Need help?
General
