4.CongurationSetup
4-5
TI 30A10A30-01E
4.3 CLI command
Basic commands to change/confirm the configuration of Managed Switch are introduced in this
section.
To save the modification for on-going usage, copying “running-config” to “startup- config” in
NVRAM is required. (See section 4.3.5)
4.3.1 Confirmconfiguration(showrunning-config)
To display the current setting of the different protocol packages supported by the switch, use
“show running-config” command. This command only displays the parameters of which values
are different from the default value
To show all the running configuration on the switch, use “show running-config all” command. This
command displays all the configuration parameters even if those values are in defaults.
Both “show running-config” and “show running-config all” commands are available in “Privileged
Exec” mode.
For recording the configuration script as a text file, use the log function of the terminal software.
A sample display of “show running-config” command execution is as shown below.
F040301.ai
(Hirschmann Railswitch) >enable
(Hirschmann Railswitch) #show running-config
!Current Configuration:
!Customized factory setting active
!
!Parameter string escape handling \, 1
!Characters to be preceded with escape char (\): \, !, ", ', ?
!System Description "Hirschmann Railswitch"
!System Version L2P-06.0.01 Build: 2010-09-24 18:18
vlan database
exit
network protocol none
network protocol hidiscovery off
!RMA operation
!RMA entry
(The rest is omitted.)
Figure Exampleof“showrunning-config”commandexecutiondisplay
The exclamation mark “!” flags the beginning of a comment. The comment flag is used to ignore
all the inputs following this mark anywhere on the command line. Any command line that begins
with “!” is recognized as a comment line and ignored.
Sep. 19, 2014-01
To Next Page
Loading...
Need help?
General
