4.CongurationSetup
4-10
TI 30A10A30-01E
4.3.4 Restoretodefault(clearconfigfactory)
To restore the Recommended Switch to default configuration, use “clear config factory”
command. This command is available in Privileged Exec mode.
By using this command, the device is restored to factory default for Vnet/IP.
Press “y” key to the confirmation message for execution of this command.
F040304.ai
(Hirschmann Railswitch) #clear config factory
WARNING: ALL configuration data will be erased from non volatile storage!
This may take up to a minute depending on your configuration.
Are you sure you want to clear the configuration? (y/n)y
Figure Anexampleof“clearconfigfactory”commandexecution
4.3.5 Save/Backupconfiguration(copy)
For Recommended Switch, several types of configuration files such as “running- config”
and “startup-config” exist. See section 3 for more information regarding the configuration file
architecture and restoring procedure of Recommended Switches.
To save the “running-config” file of the current operation in the boot up “startup-config” file, use
“copy system:running-config nvram:startup-config” command available in Privileged Exec mode.
When this command is executed while the ACA is connected, the configuration file saved in the
“startup- config” is copied to the ACA as “switch.cfg”.
Press “y” key to the confirmation message for execution of this command.
F040305.ai
(Hirschmann MACH) #copy system:running-config nvram:startup-config
Are you sure you want to save? (y/n) y
Configuration Saved!
Figure Exampleof“copysystem:running-confignvram:startup-config”display
Sep. 19, 2014-00