1-9
IM 04L51B01-17EN
Using Dedicated Commands (General)
1
1.2.5 USB Connection Procedure (GM)
The procedure to connect a GM to the PC via USB is shown below. For instructions on how
to use the PC, see the user’s manual for your PC.
Configuring the GM
Turn the USB communication function on (default value is on). For the procedure, see
section 2.19, “Configuring the USB Communication Function,” in the Data Acquisition
System GM User’s Manual (IM 04L55B01-01EN).
Connecting the GM to the PC
Connect a USB cable to the USB port.
USB port (USB mini B type)
If the PC is connected to a network environment, a USB driver will be automatically installed.
If it does not, check the download link for the driver at our website below, and install the
driver.
http://www.smartdacplus.com/en/support/software/index.html
When the USB driver installation is complete, a COM port will be assigned.
Connect using the following communication conditions.
• Baud rate: 115200
• Parity: None
• Data length: 8 bits
• Stop bits: 1 bit
• Handshake: Off:Off
1.2 Operations over the Serial Interface (RS-232, RS-422/485, USB, Bluetooth)
To Next Page
Loading...
Need help?
General
