YOKOGAWA YTA Series - 8.4 Parameter List: Setup: Event Notification & Trim

8-19
IM 01C50C05-01EN
Item
Parameter
name
Descriptions Initial setting
Setup Burst mode Burst variable
code
Setting for device variable of
cmd9 or cmd33
N/A
Event
notication
Number
of Events
supported
Maximum number of event
support
N/A
Event status Display event status N/A
Event
Notication
control
Enable event notication on
token-passing data link layer
O󰀨
Time First
Unack Event
triggered
Display event time N/A
Event
Notication
Retry time
Event notication retry time N/A
Max update
time
Maximum update time for
event notication
N/A
Debounce
interval
Debounce Interval to detect
an event
N/A
Event mask Event masking N/A
Trim Setup Device variable
trim
Sensor and CJC Trimming.
If the output value is di󰀨erent
from the trim setting value,
repeat device variable trim
procedure.
N/A
Device variable
trim reset
Reset sensor trim for factory
setting
N/A
Dev var zero
trim
Sensor and CJC
ZeroTrimming
N/A
Lower Trim
Point Value/
Upper Trim
Point Value
Lower and Upper trimming
point
N/A
Trim Point
Support
Lower and upper trim point
supported
N/A