YOKOGAWA YTA610 - 2.8 EMC Conformity Standards; 2.9 Safety Requirement Standards

<2. Notes on Handling>
2-30
IM 01C50G01-01EN
2.8 EMC Conformity Standards
EN61326-1 Class A, Table 2
EN61326-2-3
EN61326-2-5 (for Fieldbus)
Immunity inuence during the test:
Output shift is specied within ±1% of full span.
CAUTION
This instrument is a Class A product, and it is
designed for use in the industrial environment.
Please use this instrument in the industrial
environment only.
NOTE
YOKOGAWA recommends customer to apply
the Metal Conduit Wiring or to use the twisted
pair Shield Cable for signal wiring to conform the
requirement of EMC Regulation, when customer
installs the YTA Transmitter to the plant.
2.9 Safety Requirement
Standards
EN61010-1, C22.2 No.61010-1
• Altitude of installation site: Max. 2,000 m above
sea level
• Installation category: I
(Anticipated transient overvoltage 330 V)
• Pollution degree: 2
• Indoor/Outdoor use
EN61010-2-030, C22.2 No.61010-2-030
• Measurement category: O(Other)
(Measurement Input voltage: 150mVdc max)