York YMAE - Moving the Unit; Removing the Unit from the Shipping Container

Moving the unit
Before moving the unit, ensure that the installation site is suitable for installing the unit and is
easily capable of supporting the weight of the unit and all associated services.
To prevent damage to the unit from the lifting chains, lift the unit using lifting lugs and a spreader
bar or a frame of sufficient width.
CAUTION
The unit must only be lifted at the rigging plates fitted to the base frame at the points provided. Never
move the unit on rollers or lift the unit using a forklift.
Take care to avoid damaging the condenser coil fins when moving the unit.
Removing the unit from the shipping container
1. Place nylon straps through the lifting holes and forklift hole on the base. See Figure 26 and
Figure 31.
Figure 26: Nylon in lifting and fork holes
2. Attach nylon straps onto a suitable lift truck for pulling the unit out of the container.
3. Slowly place tension on the straps until the unit begins to move and then slowly pull the
unit out from the container. Pull straight so the sides do not scrape the container. See the
following figure:
41YMAE Air-Cooled Inverter Scroll Chiller and Heat Pump