York YST - Page 130

JOHNSON CONTROLS
130
FORM 160.67-O1
ISSUE DATE: 4/1/2015
SECTION 2 - OPTIVIEW CONTROL CENTER INTRODUCTION
SLOT
NO.
DESCRIPTION
2826 Governor End Bearing Temperature
2823 Shaft End Bearing Temperature
TURBINE VIBRATION SENSOR
2824 Governor End Horizontal Vibration
2825 Governor End Vertical Vibration
2821 Shaft End Horizontal Vibration
2822 Shaft End Vertical Vibration
TURBINE SOLENOIDS
2835 Turbine Rotation
2844 Trip Solenoid
2834 Trip Valve Limit Switch
2845 Vacuum Solenoid
2833 Inlet Limit Switch
2837 Oil Cooler Solenoid
2840 Bypass Solenoid
2839 Gland Solenoid
2841 Nozzle #1 Solenoid
2842 Nozzle #2 Solenoid
2843 Steam Ring Drain Solenoid
TURBINE OIL/BEARINGS
2828 Oil Temperature
2827 Oil Pressure
2873 Aux Oil Pump Run Output
2836 Aux Oil Pump Contact
MASTER SLOT NUMBERS LIST FOR USE WITH TREND FEATURE (CONT'D)
SLOT
NO.
DESCRIPTION
HOTWELL LEVEL
2576 Condensate Level
2578 Hotwell Level Control Outoput Signal
2586 Pump #1 Run Output
2579 Pump #1 Aux Output
2587 Pump #2 Run Output
2580 Pump #2 Aux Contact
2581 Low Level Switch
2582 High Level Switch
VACUUM SYSTEM
2592 Pump #1 Run Output
2593 Pump #1 Aux Contact
2595 Pump #1 Sealing Water Solenoid
2594 Pump #1 Sealing Water Flow Switch
2596 Pump #2 Run Output
2597 Pump #2 Aux Contact
2599 Pump #2 Sealing Water Solenoid
2598 Pump #2 Sealing Water Flow Switch
2608 Ejector Actuator
FLOW SWITCH
2084 Evaporator Flow
2080 Condenser Flow
2846 Steam Flow