JOHNSON CONTROLS
35
SECTION 2 - OPTIVIEW CONTROL CENTER INTRODUCTION
FORM 160.67-O1
ISSUE DATE: 4/1/2015
2
Accept Calibration
This option only becomes available after the calibra-
tion sequence is complete.
Fault Acknowledge
This option is only displayed if a fault is present. Al-
lows clearing of High Speed Thrust Bearing related
shutdowns.
NAVIGATION
Home
Access Level Required: VIEW
Causes an instant return to the Home Screen.
Compressor
Access Level Required: VIEW
Return to the Compressor Screen.
To Next Page
Loading...
