JOHNSON CONTROLS
158
FORM 161.01-OM1
ISSUE DATE: 6/8/2018
APPENDIX - MATERIAL SAFETY DATA SHEETS
CEFSHP62
Du Pont
Material Safety Data Sheet
Page 4
Printed on 03/09/2011
Extinguishing Media
As appropriate for combustibles in area.
Fire Fighting Instructions
Cool cylinder with water spray or fog. Self-contained
breathing apparatus (SCBA) is required if cylinders rupture
and contents are released under fire conditions. Water
runoff should be contained and neutralized prior to release.
----------------------------------------------------------------------
ACCIDENTAL RELEASE MEASURES
----------------------------------------------------------------------
Safeguards (Personnel)
NOTE: Review FIRE FIGHTING MEASURES and HANDLING (PERSONNEL)
sections before proceeding with clean-up. Use appropriate
PERSONAL PROTECTIVE EQUIPMENT during clean-up.
Accidental Release Measures
Ventilate area using forced ventilation, especially in low
or enclosed places where heavy vapors might collect. Remove
open flames. Use self-contained breathing apparatus (SCBA)
for large spills or releases.
----------------------------------------------------------------------
HANDLING AND STORAGE
----------------------------------------------------------------------
Handling (Personnel)
Avoid breathing vapor. Avoid liquid contact with eyes and
skin. Use with sufficient ventilation to keep employee
exposure below recommended limits. Contact with chlorine or
other strong oxidizing agents should also be avoided. See
Fire and Explosion Data section.
Storage
Clean, dry area. Do not heat above 52 deg C (125 deg F).
----------------------------------------------------------------------
EXPOSURE CONTROLS/PERSONAL PROTECTION
----------------------------------------------------------------------
Engineering Controls
Avoid breathing vapors. Avoid contact with skin or eyes.
Use with sufficient ventilation to keep employee exposure
below the recommended exposure limit. Local exhaust should
be used if large amounts are released. Mechanical
ventilation should be used in low or enclosed places.
Refrigerant concentration monitors may be necessary to
Print Date: 3 - 10 - 2011