Data Capture
64
3.
Swipe up from the bottom of the Home screen and touch .
4. Using the RS507/X or RS6000, scan the bar code on the screen.
The RS507/X or RS6000 emits a high/low/high/low beeps. The Scan LED flashes green indicating that
the RS507/X or RS6000 is attempting to establish connection with the device. When connection is
established, the Scan LED turns off and the RS6000 emits one string of low/high beeps.
A notification appears on the device screen and the icon appears in the Status bar.
5. On the device touch the Home button.
Pairing Using Bluetooth Human Interface Device
To pair the RS507X/RS6000 with the device using HID:
1. Ensure that Bluetooth is enabled on both devices.
2. Ensure that the Bluetooth device to discover is in discoverable mode.
3. Ensure that the two devices are within 10 meters (32.8 feet) of one another.
4. Place the RS507X/RS6000 in Human Interface Device (HID) mode. If the RS507X/RS6000 is already
in HID mode, skip to step 5.
a. Remove the battery from the RS507X/RS6000.
b. Press and hold the Restore key.
c. Install the battery onto the RS507X/RS6000.
d. Keep holding the Restore key for about five seconds until a chirp is heard and the Scan LEDs flash
green.
e. Scan the bar code below to place the RS507X/RS6000 in HID mode.
Figure 33 Bluetooth HID Bar Code
5. Remove the battery from the RS507X/RS6000.
6. Re-install the battery into the RS507X/RS6000.
To Next Page
Loading...