Accessories
140
CAUTION: Installer should ensure that all building codes are followed when connecting the power supplies
to an AC power source.
While installing the brackets, power supplies and cables:
• Use tie wraps to secure cables to the bracket.
• Coil cables wherever possible.
• Route power cables along wall and secure.
4-Slot Battery Charger Wall Installation
Use the Rack/Wall Mount Bracket to mount four 4-Slot Battery Chargers a cradle on a wall. When installing
on a wall, first assemble the bottom tray, install the bottom tray on the wall and then assemble the top tray.
Fasten the mounting bracket to the wall using appropriate screws and/or anchors. The Mount Bracket
mounting slots dimensions are 5 mm (0.2 in.). Fasteners must be able to hold a minimum of 20 Kg (44 lbs).
For proper installation consult a professional installer. Failure to install the bracket properly can possibly
result in damage to the hardware.
Bottom Tray Assembly
See steps 1 through 5 on page 129 for instructions.
Bracket Wall Mounting
1. Drill holes and install anchors according to the template supplied with the bracket.
2. Install two screws for bottom of bracket. The screw heads should protrude 2.5 mm (0.01 in.) from the
wall.
3. Align the mounting bracket’s bottom mounting key holes with the screws.
To Next Page
Loading...