16
ZQ220 User Guide
Removing the Battery Tape Insulator
The battery tape insulator is designed to cover the battery contacts
and allow the printer to be shipped with the battery installed.
Battery Tape
Insulator
1. Pull up on the tape insulator tab
located on the bottom of the battery
pack.
2. Peel back the tape insulator and
remove it from the top of the battery
pack. Discard upon removal.
Caution • Battery can explode, leak or catch re if improperly
charged or exposed to high temperature. Do not disassemble, crush,
puncture, short external contacts or dispose of in re or water.
Charge on a Zebra approved Lithium-Ion charger only.
To Next Page
Loading...