Zebra ZQ220 - Appendix A; USB Cables

57
ZQ220 User Guide
Appendix A
USB Cables
Part Numbers P1081545; ASSY,CABLE,USB A TO C
Type-C Plug Wire Type-A Plug
Pin
#
Signal
Name
Wire
#
Signal
Name
Pin
#
Signal
Name
A1,B1,
A12,B12
GND 1 GND_PWrt1 4 GND
A4,B4,A9,
B9
VBUS 2 PWR_VBUS1 1 VBUS
A5 CC See Note 1
-
B5 VCONN
A6 Dp1 3 UTP_Dp 3 D+
A7 Dn1 4 UTP_Dn 2 D-
Shield Braid Shield Shell Shield
Notes:
1. Pin A5 (CC) of the USB Type-C plug shall be connected to VBUS through resistor Rp (56 kΩ
+/- 5%).
2. Contacts B6 and B7 should not be present in the USB Type-C plug.
3. All VBUS pins shall be connected together within the USB Type-C plug. Bypass capacitors are
not required for the VBUS pins in this cable.
4. All ground return pins shall be connected together within the USB Tupe-C plug.
5. Shield and GND grounds shall be connected within the USB Type-C and USB 2.0 Standard-A
plugs on both ends of the cable assembly.
6. All UsB Type-C plug pins that are not listed in this table shall be open (not connected).
A1
B12
A12 A1
Pin 1
Pin 4
A1, B1, A12, B12
A6
A7
A4, B4, A9, B9