INTRODUCTION
Auto Focus equipment Notes regarding operational safety Carl Zeiss
06/2013 425131-7044-001 7
1 INTRODUCTION
1.1 Notes regarding operational safety
Auto Focus has been designed, manufactured and tested to comply with DIN EN 61010-1 (IEC 61010-1)
Safety requirements for electrical equipment for measurement, control and laboratory use.
The device complies with EC Directives 2006/95/EC, Low Voltage Directive and 2004/108/EC,
Electromagnetic Compatibility. The device must be disposed of in accordance with the WEEE Directive
2002/96/EC.
Auto Focus carries a mark.
This operating manual contains information and warnings that must be followed by the owner/operator
personnel.
The warnings and advisory notes used throughout this operating manual have the following meanings:
WARNING
This symbol indicates a potential hazard to the user.
WARNING
This symbol indicates a potential danger of IR radiation exposure created by operator action.
WARNING
Disconnect mains plug before opening the device!
CAUTION
This symbol indicates a potential hazard to the instrument or system.
NOTE
This symbol designates information that should be closely followed.
STANDBY
The Auto Focus should not be used in any other way than as described in this operating manual. The
microscope manual should also be consulted where appropriate.
To Next Page
Loading...
