Zeiss Stemi 508 - Page 24

INSTALLATION Stereo microscope
ZEISS Installing the stereo microscope Stemi 508
24 435064-7044-001 01/2015
• Insert glass plate or B/W plastic plate (Fig. 7/6)
in the mount in the base of the stand. To this
effect, press the glass plate or the B/W plastic
plate against the spring (Fig. 7/7) and make it
lock in.
Installation of a reflected-light
illumina
tor has been described in
Section 3.3.1 on page 25.
If necessary, the ease of motion of the
focusing drive can be set as required
on a case-by-
case basis by adjusting
the two focusing knobs (Fig. 8/1 and
2) in opposite directions.
The ease of motion must not be set so
loosely that the drive moves
down
wards by itself. This might
damage the microscope or the
specimen.
Fig. 7 Installing the stereo microscope
Fig. 8 Setting the ease of motion of the
focusing drive