ZF AV 110 - Page 107

15. Insert the tapered roller bearing into the
int
ermediate gear.
16. Place intermediate gear and tapered roller
bearing onto a bush (thrust washer) in the
portal housing.
Fig. 208
17. Grease O‑rings (1) and insert them into the
annular g
rooves.
18. Glue the determined shim (2) with grease
onto the bearing bolt.
19. Bolt 5870.204.022 [Locating pin] (3) into the
bearing bolt.
Fig. 209
20. Slide the bearing bolt into the portal housing
and f
ix intermediate gear and tapered roller
bearing.
21. Remove 5870.204.022 [Locating pin].
Fig. 210
Assembly
EN 4472.751.001 - 2015-11
107