Page 38 of 40 801910 - Zip Sparkling HydroTap - Installation Instructions - July 2014 - v1.00
Trouble Shooting
System Fault
Message
Possible Cause Solutions
Power Board Fault Electrical disruption Check power supply and all fuses
Interface Fault Internal fault Call Zip Service
Level Board Fault Internal fault Call Zip Service
Condenser Screen Blocked Blocked Air filter Remove blockage / Clean filter / check user guide
Water leak, Isolate Mains Water leak Turn off mains water supply / Call for service
Compressor Over Run Compressor too Hot Check ventilation
Water Supply Failure No water Check water supply is turned ON
Hot Sensor Open Internal fault Call Zip Service
Hot Sensor Closed Internal fault Call Zip Service
Cold Sensor Open Internal fault Call Zip Service
Cold Sensor Closed Internal fault Call Zip Service
Flood Sensor Open Internal fault Call Zip Service
Condenser Sensor Closed Internal fault Check Ventilation / Call Zip Service
Condenser Sensor Open Internal fault Check ventilation / Call Zip service
Heater Driver Fault No hot water Call Zip Service
Compressor. Driver Fault No chilled water Call Zip Service
Hot Sensor Degraded Internal fault Call Zip Service
Condenser Overtemp Blocked airfilter Remove blockage / Clean filter / check user guide
Steam too Cool Internal fault Call Zip Service
Steam Sensor Open Internal fault Call Zip Service
Steam Sensor Closed Internal fault Call Zip Service
Hot Overload Internal fault Turn OFF to reset / Call Zip Service
Hot Tank Overfilled Internal fault Call Zip Service
Safety Lock ON Safety button active See User guide Section - G (Safety mode)
Safety Lock OFF Safety button Inactive See User guide Section - G
Hot Isolation ON Safety button active See User guide Section - G
Hot Isolation OFF Safety button Inactive See User guide Section - G
Hot Isolation Enable Safety button active See User guide Section - G
Hot Isolation Disable Safety button Inactive See User guide Section - G
Sleep Mode Enable Auto sleep mode active See User guide Section - G (Energy Mode)
Sleep Mode Disable Auto sleep mode inactive See User guide Section - G (Energy Mode)
Calibration Auto calibration reset Normal operation, once per month
Overload Reset Internal fault Call Zip Service
Call an electrician, a plumber, or Zip for a free call in Australia on 1800-638-633 for assistance, service, spare
parts or enquiries.
In order to help preserve our environment we ask that you dispose of this product correctly. Please contact
your local city council for collection centre details.
End of Life Disposal
To Next Page
Loading...
