SW3
GIGABIT/FAST ETHERNET SWITCH TYPE SW3 (DIN) 99/122
USER GUIDE - M0SW3D1905Iv04 - V04 May 2019
Configuration commands
add Adds a new item to the matrix of a matrix-type parameter.
Syntax: swt /> add name
Arguments:
name Parameter to which a new item is to be added.
Observations: To add a new item to a matrix-type parameter, it is
necessary to be in the directory in which it is located or
enter the relative route.
The new item created has the next order number with
respect to the last one. For instance, if nat[1] and nat[2]
already existed, on running the command add nat the item
nat[3].
Examples: swt /> add nat
swt /wan> add tunnel/tunnel
swt /admin> add ../nat
apply This applies the configuration changes in the equipment, but without saving
them.
Syntax: swt /> apply
Arguments: -
Observations: This command can be used irrespective of the directory
where the user is.
This command DOES NOT save the changes made.
Example: swt /> apply
download This carries out a copy (back up) of the parameters configured in the
equipment, which have a value different from the default value (factory) to be
carried out. For this reason, this command is useful for configuring equipment
with the same parameters as the current one.
Syntax: swt /> download
Arguments: -
To Next Page
Loading...
