SpeedFace M1/M2
User Manual
Page | 10 Copyright©2020ZKTECO CO., LTD. All rights reserved.
• If eyeglasses have been changed, authentication may fail. If the face without glasses has
been registered, authenticate the face without glasses. If only the face with glasses has been
registered, authenticate the face with the previously worn glasses again.
• If a part of the face is covered with a hat, a mask, an eye patch, or sunglasses authentication
may fail. Do not cover the face, allow the device to recognize both the eyebrows and the
face.
1.4 Standby Interface
After connecting the power supply, the interface appears as shown below:
Note:
1） Click to open the interface to enter the User ID.
2） When there is no super administrator registered in the device, click to enter the menu. After
setting the super administrator, it requires the super administrator’s verification before entering
the menu operation. For the security of the device, it is recommended to register a super
administrator the first time you use the device.
To Next Page
Loading...
Need help?
General
