SpeedFace M1/M2
User Manual
Page | 36 Copyright©2020ZKTECO CO., LTD. All rights reserved.
DNS
The factory default address is 0.0.0.0. Please set the value as per the
requirements.
The factory default value is 4370. Please set the value as per the requirements.
DHCP
Dynamic Host Configuration Protocol, which is to dynamically allocate IP
addresses for clients via server.
To set whether to display the network icon on the status bar.
5.2 PC Connection
To improve the security of data, please set a Comm Key for communication between the device and the
PC.
If a Comm Key is set, this connection password must be entered before the device can be connected to the
PC software.
Click PC Connection on the Comm. Settings interface.
Comm Key
Comm Key: The default password is 0, which can be changed. The Comm Key
may contain 1 to 6 digits.
Device ID
The identity number of the device, which ranges between 1 and 254. If the
communication method is RS232/RS485, you need to input this device ID in the
software communication interface.
To Next Page
Loading...
Need help?
General
