SpeedFace M1/M2
User Manual
Page | 65 Copyright©2020ZKTECO CO., LTD. All rights reserved.
9.6 Duress Options Settings
If a user activated the duress verification function with specific authentication method(s), when he/she is
under coercion during authentication with such method, the device will unlock the door as usual, but at
the same time a signal will be sent to trigger the alarm.
Click Duress Options on the Access Control interface.
Alarm on Password
When a user uses the password verification method, an alarm signal will be
generated; otherwise there will be no alarm signal.
Alarm Delay (s)
Alarm signal will not be transmitted until the alarm delay time is elapsed. The
value ranges from 1 to 999 seconds.
Duress Password
Set the 6-digit duress password. When the user enters this duress password for
verification, an alarm signal will be generated.
To Next Page
Loading...
Need help?
General
