SpeedFace M1/M2
User Manual
Page | 49 Copyright©2020ZKTECO CO., LTD. All rights reserved.
6.6 Detection Management
Click Detection Management on the System interface.
Enable mask
detection
To enable or disable the mask detection function.
When it’s enabled, the device will identify whether the user is wearing a mask
or not during verification.
Deny access without
mask
To enable or disable the deny access without mask function.
When it’s enabled, even if the body temperature is normal, the person who
does not wear a mask will not allow the person to enter.
Allow unregistered
people to access
To enable or disable the unregistered people to access function.
When enabled, as long as the person who passes the detection, the device
allows the personnel to enter without registration.
alarm
When enabled, if the
user's temperature is higher than the set value or the
mask detection is enabled, but the mask is not worn, it will trigger an alarm.
Clear the triggered alarm records of the device.
delay(s)
The delay (s) time for triggering an external alarm can be set in seconds, users
may disable the function or set a valid value between 1 to 255.
To Next Page
Loading...
Need help?
General
