Safety instructions 9
Fig. 3.1 Driving limitations with weighted footboards
Footboards monitoring function (see chapter 5.2.4) must be tested each time the engine is
started. In case of negative test results, the compaction mechanism is blocked.
o In the event of malfunctioning reverse driving blockade or an emergency traffic
situation it is possible to restore vehicle manoeuvrability by pressing the restriction
override button on the ZCS-Command module in the cab. To activate button, the
footboards must be weighted.
o After the fault has been rectified or the emergency road situation has ended, the
restriction override button can be returned to its original position. For this
purpose, the vehicle with the engine running must be stationary. Safety devices and
travel restrictions will be reactivated. After 5 minutes, the vehicle will be ready to work.
Do NOT use the restriction override button as an emergency stop button, because the vehicle is
ready to work after 5 minutes.
o Under no circumstances operators can stand on the vehicle parts that are not intended
for this purpose. Driving is only allowed in the driver's cab or on the footboards. When
driving on footboards, hold on to the handles at the rear of the vehicle. Driving on
footboards with a speed exceeding 30km/h is prohibited. Only one operator can travel
on the unfolded footboard.
o When working with the tailgate raised, it is forbidden to lean it on the road
It is forbidden to stand under raised, unsecured tailgate! It is also forbidden to stand on the footboards
during raising the tailgate!
o It is allowed to drive with the tailgate raised only when emptying the body, and on a
distance not longer than the body length.
To Next Page
Loading...