Safety instructions 10
o Each vehicle is equipped with a space control system behind the vehicle (camera and
video on the display of the terminal in the cab) to monitor the work area. The camera
must be positioned so that the operator's working area behind the vehicle is visible.
o Before starting work, check if the space control system behind the vehicle is working
properly. Reverse gear must not be engaged without a functional space control system
behind the vehicle!
o Observe the information on the information and warning signs. Make sure that they are
visible before each start-up.
o During work, personal protective equipment must be used (see chapter 3.8: Safety and
health issues).
o Keep long hair under the headgear.
o In the event of injury, accident, skin irritation or allergic reaction, contact a doctor
immediately.
o For work that generates large amounts of dust and aerosols, wear a suitable protective
mask!
o During travel and bodywork operation, all tailgate covers must be closed. Example of
placement of the covers on the tailgate is shown below. Type and placement of the
covers depends on type of the vehicle.
Fig. 3.2 Example of covers on tailgate
o Space between the body and driver’s cab and space in the body behind the pushing
wall should always be empty – do not gather there any waste or other materials.
High temperatures occur in the spaces between the body and the driver's cab and behind pushing wall.
It should be ensured that there is no waste (especially flammable) left there, because they may cause the
fire.
To Next Page
Loading...