ZOLL aed pro - Page 20

CHAPTER 1 MAINTENANCE TESTS
1–8 www.zoll.com 9650-0309-01 Rev. E
.
5.7
Press VFIB on the Defibrillator
Analyzer.
After 2 minutes (default setting),
Verify the unit prompts STOP
CPR, followed by DON’T
TOUCH PATIENT
ANALYZING twice, followed
by SHOCK ADVISED,
DON’T TOUCH PATIENT,
PRESS FLASHING SHOCK
BUTTON.
 
5.8
Press Flashing Shock button Verify that unit prompts
SHOCK DELIVERED.
 
5.9
2
nd
shock energy test (default
value 150 joules)
Verify the Energy delivered into
analyzer is 122 joules to 166
joules.
 
5.10
Verify the unit prompts START
CPR, followed by CONTINUE
CPR.
 
5.11
Press VFIB on the Defibrillator
Analyzer.
After 2 minutes (default setting),
Verify the unit prompts STOP
CPR, followed by DON’T
TOUCH PATIENT
ANALYZING twice, followed
by SHOCK ADVISED,
DON’T TOUCH PATIENT,
PRESS FLASHING SHOCK
BUTTON.
 
5.12
Press Flashing Shock button Verify that unit prompts
SHOCK DELIVERED.
 
5.13
3
rd
shock energy test (default
value 200 joules)
Verify the Energy delivered into
analyzer is 155 joules to 211
joules.
 
5.14
Press and hold the On/Off
button to power off the unit.
Verify unit displays UNIT
POWERING OFF message.
 