ZOLL aed pro - Chapter 1 Maintenance Tests; Preparations for Testing; Test Equipment

CHAPTER 1 MAINTENANCE TESTS
1–2 www.zoll.com 9650-0309-01 Rev. E
Preparations for Testing
• Gather the required equipment listed in the next section.
• Perform all the steps within each test procedure in the order specified.
If testing results indicate that the battery pack must be replaced, you will need a fully charged
spare battery pack.
Test Equipment
For some tests, you need one or more of these items:
• ZOLL defibrillation analyzer (universal) adapter cable (8000-0804-01)
• Defibrillator Analyzer (e.g. QED 6) or Fluke Impulse 4000 Defibrillator/Pacer Performance
Analyzer (Fluke Biomedical/ DNI Nevada) with 1.06 software or higher
• Battery Current Test Fixture (P/N 9100-0690-TF),
• Power Supply 12V 10A,
• AED Plus
®
, Quick-Test, Test Fixture (P/N 9100-0567-TF)
• DMM (e.g. Agilent 34401A Digital Multimeter) or equivalent.
• AED Pro Disposable Battery (P/N 1008-002003-01)
• SurePower
®
Rechargeable Li-Ion Battery (P?N 1009-001535-03)
• PC with ZOLL RescueNet
®
Code Review and ZAS (ZOLL Administration Software, P/N
7771-000012-01),
• ZOLL USB IrDA port (P/N 9355-0807).
• PC with AED Plus/PRO DCI Panel software (P/N 9103-0815-SW),
• AED Pro Resistance, Decade Box (P/N 9100-000957-TF) or equivalent (e.g.RS-200
Resistance Substituter).
• ZOLL 3-lead ECG cable (8000-0838 or 9500-001802)
• USB Flash Drive (P/N 8000-000474),
For ZOLL part numbers, refer to the accessories list in the AED Pro Operator’s Guide.