5. Use to select “Timecode” and press .
Searching for the device to connect will begin and “Searching” will appear on the display.
NOTE
If the H4essential and the UltraSync BLUE have been connected, when a screen like the following appears,
make a selection.
Setting Explanation
Paired Device Select this to connect to the UltraSync BLUE that was
connected the previous time.
In this case, connection will be made with the UltraSync BLUE
and its operation described in step 6 becomes unnecessary.
New Device Select this to connect to a different UltraSync BLUE than the
one that was connected the previous time.
Selecting “New Device” will erase information about the
previously paired device. Proceed to step 6.
HINT
Searching can be canceled by pressing .
109
To Next Page
Loading...
