NOTE
• The volume output from the PHONE/LINE OUT jack is also affected by volume adjustments made on
the Mixer Screen. Adjust the headphone volume after adjusting the input mix levels. (→ Adjusting the
monitoring balance of input sounds)
• The built-in speaker cannot be used for monitoring while recording.
• When “Volume Control” is set to “Fixed”, cannot be used to adjust the volume. To use
for volume adjustment, set “Volume Control” to “Knob”. (→ Making output settings)
HINT
• When monitoring with headphones is unnecessary, disconnecting headphones from the PHONE/LINE
OUT jack can increase the amount of operation time when using batteries.
• The volume of each input can also be adjusted separately. (→ Adjusting the monitoring balance of input
sounds)
60
To Next Page
Loading...
