Zte ZXHN H3601 - Configure the Local Service Control

ZXHN H3601 Maintenance Management Guide
Parameter Description
Egress Specify the data traffic direction. The Ingress option and
egress option cannot be the same.
 If the ingress is LAN, the egress should be a WAN or 3G
connection. The data traffic direction is upstream.
 If the ingress is a WAN or 3G connection, the egress
should be the LAN. The data traffic direction is
downstream.
DSCP A DSCP is specified for the TOS byte in the IP header of each
packet to indicate the priority. Range: 0–63.
3. Click Apply button to apply the changes.
5.4.3 Configure the Local Service Control
The section describes how to configure local service control.
Steps
Service Control-IPv4
1. On the main page of the ZXHN H3601, select Internet > Security > Local Service
Control to the Local Service Control page.
2. Click Service Control-IPv4 to open Service Control-IPv4 page, see Figure 5-16.
Figure 5-16 Service Control-IPv4 Page
3. Configure the service control-IPv4 parameters.
Table 5-10 lists the local service control-IPv4 parameters.
5-16 SJ-20200429083356-004 | 2020-07-23(R1.0)