Zte ZXHN H3601 - Configure the Port Forwarding

ZXHN H3601 Maintenance Management Guide
Figure 5-20 DMZ Configuration Page
Table 5-13 lists the DMZ parameters.
Table 5-13 Parameter Descriptions for the DMZ
Parameter Description
DMZ Switch Enable the DMZ host function.
LAN Host The IP address or the MAC address of the computer at the LAN
side.
2. Click Apply button to apply the changes.
5.4.6 Configure the Port Forwarding
This procedure introduces how to configure Port Forwarding so that a computer from
the external network can access the LAN-side server through the WAN connection. Port
Forwarding provides the parameters of Port Forwarding configuration features.
If you have local servers for different services and you want to make them publicly
accessible, you need to specify the port forwarding policy. With NAT applied, it translates
the internal IP addresses of these servers to a single IP address that is unique on the
Internet.
To the Internet users, all virtual servers on your LAN have the same IP Address. This IP
Address is allocated by your ISP. This address should be static, rather than dynamic,
to make it easier for Internet users to connect to your servers. However, you can use
dynamic DNS feature to allow users to connect to your virtual servers by using a URL,
instead of an IP address.
Steps
1. On the main page of the ZXHN H3601, select Internet > Security > Port
Forwarding to the Port Forwarding page, see Figure 5-21.
5-20 SJ-20200429083356-004 | 2020-07-23(R1.0)