Zte ZXHN H3601 - Configure the FTP Server Feature

ZXHN H3601 Maintenance Management Guide
Parameter Description
Destination IP Address Destination IPv6 address of the matching
packets.
Protocol Matching IPv6 protocol. The ANY option means
any IPv6 protocol.
Source Port Source port number of the matching packets.
Destination Port Destination port number of the matching
packets.
Source MAC Address MAC address of the source device that sends
the matching packets.
3. Click Apply button to apply the changes.
6.5 Configure the FTP Server Feature
This procedure describes how to enable the FTP feature of the ZXHN H3601 by
configuring FTP parameters, including the username and password.
Steps
1. In the left navigation tree, click Local Network > FTP. The FTP Application page is
displayed, see Figure 6-23.
Figure 6-23 FTP Page
2. Set the parameters. For a description of the parameters, refer to Table 6-16.
Table 6-16 FTP Server Parameter Descriptions
Parameter Description
Server Enable or disable the FTP server feature .
FTP Username/FTP
Password
Username and password used to connect to the FTP server.Valid
only if FTP security control is enabled.
3. Click On to enable the FTP server feature ,and click Apply button to apply the
changes.
6-20 SJ-20200429083356-004 | 2020-07-23(R1.0)